Subject: IC-T22A Mod I have found two mods for this perticular radio thanks to Thayer (1) To expand receive from 136-174MHz FM to 136-174/270-410MHz FM: 1. Turn radio off 2. Hold MR & UP SCAN arrow down while turning radio on... don't release for 5 seconds 3. Go into the set mode by pressing the function & 8 4. You are looking for the function " 1 PL " 5. Turn the main tuning knob until you see " 100 PL ". This enables direct freq. entry 6. Press Clear to return to VFO mode. (2) Regarding the mods for the Icom T22A, first remove the battery and antenna. Separate the case by removing the four black phillips screws and two bottom silver phillips screws (leave the two top silver phillips screws alone). On the half that has the PTT switch and 'front' of the radio, locate a bank of diodes just to the right and below the printing 'UHF'' on the circuit board down near the lower right side of the board. There are four of them, three black with 'AY' printed on them and having three leads on them, one silver having the number '18' on it and only two leads. If you are holding the radio parts vertically, (the printing 'UHF' is right side up), then the block of four will be: AY 18 (blank) AY Using a micro solder iron with a pointed tip - be careful to apply just enough heat to loosen the top '18' and 'AY' diodes and lift all but one of the leads off of each with a jeweler's screwdriver or the tip of an x-acto knife. By leaving one of the leads attached you have the option of reattaching them if you choose to. These diodes are so small you would otherwise lose them and if you ever need to send the radio back to Icom for repair the warranty would be voided. I also use a loupe to better see what I'm doing. Because there's not much clearance (these things are about the size of a pinhead) you have to be VERY careful with the soldering iron. This will give you all the extended ranges of the radio. Good luck and keep a steady hand, Thayer