Subject: Kenwood TH28 Mod

To transfer memories from one radio to another,you can clone two TH-28a's.
Each radio must	either have the	ME-1 installed or no ME-1 installed,but	they
both must be the same!

Radio A	will be	the radio that SENDS the memories!
Radio B	will receive the memories!

1.Turn on Radio	B and enter say	144MHZ into all	the memories you are going to
CLONE TO.
2.Say radio A has 125 memories,enter 144MHZ into 125 of	radio B's memories.
This ENABLES or	turns ON radio B's memories.
3.Turn both radios off then on.
4.Enter	a simplex frequency into both radios and make sure you use the VFO
mode.
5.Turn on radio	A while	pushing	button 7 at the	same time,the display should
read"CLONE".
6.Turn on radio	B while	pushing	button 7 at the	same time,the display should
read"CLONE".
7.Press	PTT or push-to-talk on radio A!
8.You will hear	tones on both radios which go real fast	and vary in pitch.
9.Leave	the radios for about 15-20 minutes so they can finish.
10.The tones will be repititous-this will indicate the transfer	was successful.
11.Turn	off radio A,you	might hafto disconnect the battery.
12.Turn	off radio B,then check the memories.

This does work,I tried it myself 125 memory transfer in	15 minutes PL's,odd
offsets	and all.Call channel is	not transferred!If this	does not work,try a
few times.
Special	thanks to N2OUM	and N2PPT!

				73 DE N2PPV