Subject: Submitting TH-G71A Radio Mod. Date: Mon, 12 Oct 1998 03:45:08 PDT TH-G71A "Beyond MARS" Mod 1. Remove the battery pack and antenna 2. Open the SPKR/MIC dust cover. 3. Remove the three screws from the back panel of the transceiver. 4. Carefully lift up the bottom end of the back panel and pull the entire back panel toward the bottom of the transceiver to clear the antenna connector from the top panel. Do not break the ribbon cable that connects the back panel PCB to the front case PCB. 5. Set the back panel to the left of the front case. 6. Locate* and remove surface mount diodes D512 (Receive Extend) and/or D513 (Transmit Extend) from the bottom right side of the front case PCB. If the green jumper wire has been cut previously, reconnect it at this time. 7. Assemble the transceiver by reversing the steps above. The unit will reset when powered up. * Diode D512 is oriented vertically and located at the bottom left of a trio of SMC parts. These three parts form a "Pi" like shape approximately 1/4 of the distance from the right hand side of the front PCB when the radio is placed face down, bottom of the unit towards you. D512 is the right "leg" of the "Pi". D513 is to the right of this group and slightly closer to the edge of the board it is also oriented vertically, near the bottom left corner of a larger rectangular component. The green wire is to the right of the larger component. NOTE: this change also allows the transceiver to access a previously suppressed menu, number 16. This menu allows the unit to switch between FM and AM Rxr detection in the 118 -136 mHz band. Resulting Operational Ranges: TX: 136.000mHz - 173.995mHz, 400.000mHz - 469.995mHz RX: 118.000mHz - 173.995mHz, 320.000mHz - 469.995mHz, 800.000mHz - 823.9875mHz, 849.000 - 868.9875mHz, 894.000mHz - 949.9875mHz